7.15 Oil Filtration / Cooling 210
7.15.1 Oil dipstick – Marking 210
7.15.2 Engine oil filter – Replacement 211
7.15.3 Centrifugal oil filter – Cleaning and filter-
sleeve replacement 213
7.16 Coolant Circuit, General, High-
Temperature Circuit 216
7.16.1 Drain and venting points 216
7.16.2 Engine coolant – Level check 221
7.16.3 Engine coolant – Change 222
7.16.4 Engine coolant – Draining 223
7.16.5 Engine coolant – Filling 224
7.16.6 HT coolant pump – Relief bore check 225
7.16.7 Engine coolant – Sample extraction and
analysis 226
7.17 Raw Water Pump with Connections 227
7.17.1 Raw water pump – Relief bore check 227
7.18 Belt Drive 228
7.18.1 Drive belt – Condition check 228
7.19 Battery-Charging Generator 229
7.19.1 Battery-charging generator drive – Drive belt
check and adjustment 229
7.19.2 Battery-charging generator drive – Drive belt
replacement 231
7.20 Engine Mounting / Support 233
7.20.1 Engine mounting – Checking condition of
resilient mounts 233
7.21 Wiring (General) for Engine/Gearbox/Unit 234
7.21.1 Engine wiring – Check 234
7.22 Accessories for (Electronic) Engine
Governor / Control System 235
7.22.1 Engine governor and connectors – Cleaning 235
7.22.2 Engine monitoring unit and connectors –
Cleaning 236
7.22.3 Start interlock limit switch – Check 237
7.22.4 ECU – Checking plug connections 238
7.22.5 Engine monitoring unit – Plug connection
check 239
7.22.6 Engine control unit – Removal and installation 240
7.23 Emergency Instrumentation (Local
Operating Panel) 242
7.23.1 LOP and connectors – Cleaning 242
7.23.2 LOP – Visual inspection 243
7.23.3 LOP – Test procedures 245
8 Appendix A
8.1 Abbreviations 247
8.2 MTU contacts/service partners 250
9 Appendix B
9.1 Special Tools 251
9.2 Index 255
MW15550/06E 2012-02 | Table of Contents | 5
DCL-ID: 0000013394 - 002
To Next Page
Loading...
