MULTILIFT Ultima S Flex - Page 138

138
Ultima S / SL Flex & Pro
3/2019
114060421
Hooklift Multilift Ultima S / SL Flex & Pro
User Manual
>>>
Weighing calculation done
When the final calculation
result is ready, there will be a
green ‘OK’ symbol is shown left
to the weight reading.
Center of gravity (CoG) of
the load is now also shown.
Horizontal CoG is measured
from the back of the container,
vertical CoG from the bottom
on the container.
Load Estimation
When the nal load calculation
result is not yet ready, a small
red ‘X’ symbol is shown left to
the weight reading.
Center of gravity (CoG) of the
load is not calculated.
NOTE!
The nal calculation result is valid for the container measurements given in the
system calibration!
Truck information
If the truck is tted with a body builder interface to which the hooklift is connected, information
about the truck is shown on the display. Some truck related controls are also available, such
as PTO on/o󰀨 switch and RPM control, depending on the truck conguration.