TM1215 Iss. 6.0 RPR750
2.4.17 Speech (BEEP Tone) Volume Adjustment (not POCSAG variants)
To adjust the volume of the speech messages and beep tone where programmed as an
option, the pager must be in the quiescent state. First push the MUTE button, followed by
the OCR button. The display will show the current volume level and this may then be
adjusted by further pressing the OCR button to increase the volume, or the MUTE button
to decrease. When the desired level is reached, release any buttons and the pager will
return to its quiescent state.
2.4.18 Tone & Speech Only Calls
If there are no messages, or speech associated with a call, then the message display will
show as "tone call n" for the duration of the alert, where n is the Multitone Beep Code
number (see Section 2.4.6, Table 2).
For a "speech only" call (not POCSAG variants) the message display will read as speech.
In both instances, messages may be preceded by a time stamp or message number.
2.4.19 Beep Code Alpha
Beep Code Alpha is when one particular pre-programmed message is always assigned to
a specific beep code. When this code is received, the same message is always activated
and displayed. Up to 4 alphanumeric beep code messages, each of up to 14 characters in
length, may be programmed into a pager.
2.5 OPTIONS & FEATURES
2.5.1 Time Of Day
The Time Of Day function may be derived from either one of two sources. If the system on
which the pager is to be used has an "off-air" time signal, then this option may be enabled
during the software programming of the pager. Alternatively, if time notification is required
on a pager not allocated to a system with an "off-air" time signal, then the internal clock
may be activated.
Time is displayed during quiescent conditions and takes the form: -
Hours: Minutes
3:17
15:17
Where time has not been selected, then the pager will display on status. Time will be
overridden by higher priority status messages such as new message, out of range and
low battery.
Off-air time signal - If this option has been selected, the display will show the symbol --:--
in the quiescent state, until the first valid time signal (transmitted every minute) has been
received from the system. If the pager should go out of range of the system and no time
signal is received for 2 minutes, then this symbol will also be displayed until a valid signal
is again received.
Internal clock - where the off-air time signal option is not enabled, it is possible to activate
and set the pager's internal clock. To set the time, press the CANCEL button during the
switch-on sequence and the time-of-day screen will be displayed. This screen will initially
show the hours flashing.
16
To Next Page
Loading...
