Page18of33
IMC08 Banknote Counter & Sorter User Manual
Version 1.03
Figure 5-15 SDCV Mode
5.5. Counting Function Options
5.5.1. Automatic Banknote Counting
Press the AUTO key to enable or disable the automatic banknote counting in the main interface.
After turning the IMC08 on it will default to the automatic counting mode, an “AUTO” will be displayed on
the main screen. In this mode the IMC08 start counting automatically.
Figure 5-16 AUTO Function Indicator
To operate with the manual counting mode, by pressing the AUTO key, the “AUTO” indicator will be off.
In this mode, the IMC08 stops counting automatically, and the RESTART key must be pressed to start each
count.
5.5.2. Serial Number Reading
The SN key is used to enable or disable the function that reads the banknote’s Serial Number.
After turning the IMC08 on, the default is to turn on this function. An “SN” will be displayed on the main
screen. The SN reading function records the unique serial numbers of the counted banknotes. This function
is available for the following currencies as of this writing: USD, EUR, GBP, CAD, MXN.
Figure 5-17 SN Function Indicator
5.5.3. Add Function
This function is toggled on via the ADD key. It is used to cumulatively add the counting results of multiple
counts to the total. When the add function is activated, an “ADD” indicator will be displayed on the main
screen. Press the ADD key again to disable the add function.
Figure 5-18 Add Function Indicator
5.5.4. Face Function
This function is available by pressing the FACE key in SDC mode until “FACE” is displayed on the main
screen.
It allows the user to sort the banknotes based on whether they are loaded into the hopper face up or face
down. This first note in the hopper determines the sorting and counting orientation. If the first note through
the machine is face up, all notes in the hopper that are face up will end up in the stacker, and the other notes
will end up in the reject pocket. Total number and value will be displayed on the main screen.
5.5.5. Orient Function
This function is available by pressing the ORI key in SDC mode until “ORI” is displayed on the main screen.
This function allows the user to count and sort the notes by one of 4 orientations. The fist note in the hopper
determines the counting orientation. Any time a note passes through the machine and does not conform to
the orientation determined by the first note, the machine will reject this note into the reject pocket. Total
amount and number of the notes will be displayed on the home screen.
To Next Page
Loading...
