2-7Network settings
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
Network settings
Gateway address
Register the gateway address. The gateway acts as a router that connects one sub-
net to other subnets to allow communication between them.
1
Open the TCP/IP setting menu display. (Refer to page 2-2.)
2
Press [Gateway1].
3
Enter the appropriate IP address using the numeric keys and press [Enter].
Press the arrow keys to navigate the IP address fields. To delete a number,
press [Clear].
4
In the same way, enter an IP address of [Gateway2] (secondary gateway).
NOTE: If you do not wish to set a secondary Gateway, enter “0.0.0.0” or press [Clear] to
delete the IP address.
5
Press [Enter]. The display returns to the TCP/IP setting menu.
You may configure additional settings.
To return to the Standby mode, press [Reset].
6
After you have completed registering the network settings, the machine
should be rebooted to enable the new settings. To reboot the machine, turn the
machine “Off” and after three or more seconds, turn the machine back “On”
To Next Page
Loading...
Need help?
General
