Manual Cube67+ | System Manual
35
3.5 Electromagnetic Compatibility (EMC)
This device meets the requirements of EC Directive 2004/108/EEC "Electromagnetic
Compatibility".
This device is Class A equipment and may cause radio-frequency interference in res-
idential areas. In this case, the operator may be required to implement adequate
countermeasures.
The devices described in this manual each meet the relevant standards for electromagnetic compati-
bility. However, this does not mean that their electromagnetic compatibility is still guaranteed when
installed in a plant or machine.
For this reason, we urgently advise you to comply with the instructions on installation in accordance
with EMC requirements below. Only then can you assume that the overall system complies with EMC
requirements, provided CE-marked components are used exclusively.
Protection against Electrostatic Discharge
The products described in this manual contain complex semiconductor components which may be
destroyed or damaged by electrostatic discharge (ESD).
Damage does not necessarily lead to immediate, detectable failure, or malfunction. These states may
be even delayed, or occur sporadically.
The generally accepted safety precautions for ESD sensitive devices must be observed when han-
dling the devices. The following precautions must be taken:
Never plug or unplug connectors while the equipment is under power.
If you are an operator, discharge any static charge you may be carrying just before
you touch the equipment. For example, you can touch a grounded part of the ma-
chine, or wear an ESD discharge strap that is permanently connected to ground.
To Next Page
Loading...
Need help?
General
