MUTOH VC-600 - Appearance of Valuecut; The Front View; The Back View

ValueCut Kullanım Kılavuzu
General Information 1-3
1.4 Appearance of ValueCut
1.4.1 The Front View (Şekil 1-1)
1.4.2 The Back View (Şekil 1-2)
Pinch Rollers –
hold the media during
cutting.
Lever –
raises or lowers the
pinch rollers.
Şekil 1-2
Control panel – consists of 14
control keys and 1 LED and 1 LCM
showing messages and menus.
Cutting Pad – provides the
protection of blade when the blade is
cutting.
Tool Carriage – performs the
cutting with the installed blade
and pen with AAS module.
Alignment Rulers –
media can be aligned
with the clear guide line
marks.
Grid Drums – move
the media back and
forth during operation.
Slicer Groove –
slice off the extra
media easily along
this groove.
Platen –
provides the
surface for holding and
supporting media while
performing cutting.
Şekil 1-1