- 52 -
CONTROLS AND INSTRUMENTS 3
3
EN
Engine stop switch
It is used to switch off the engine in an emergency. The ignition circuit is disabled, preventing the engine
from being restarted. To be able to restart the engine, return the switch to its original position.
DANGER! If the throttle of your motorcycle sticks, you must use the engine stop switch to
stop the delivery of power from the engine. Failure to use the stop switch in such a situa-
tion can result in loss of control of your motorcycle, serious injury or even death.
DANGER! Before restarting the engine, you must determine the cause of the stuck throttle
and effect the necessary repair. If necessary, take your motorcycle to a qualified mechan-
ic. Failure to do so could result in an accident, personal injury or death.
NOTE
Under normal conditions, do not use this switch to shut off the engine.
Engine start button
It is used to start the engine and, when the engine is running, to select the different functions of the dis-
play installed on the instrument panel.
CAUTION: To avoid damaging the electrical equipment, be sure not to hold down the but-
ton for longer than 5 consecutive seconds.
If, after some attempts, the engine does not start, refer to the chapter “TROUBLESHOOT-
ING” later in this manual.
To Next Page
Loading...
