MV Agusta F3 - SPEED LIMITER Mode

- 74 -
OPERATION 4
4
EN
4.4.3. “SPEED LIMITER” mode
When starting the engine, the “SPEED LIMITER” func-
tion is disabled. In order to activate it, it is necessary to
perform the following operations:
Press “SET” in order to access to “SPEED LIMI-
TER” mode. The maximum speed value shown on the
display (equal to the current speed of the vehicle) starts
blinking.
NOTE: The maximum speed may be changed
or set even during the use of the vehicle.
Press “SET” for less than three seconds: the maxi-
mum speed value is decreased of 2 km/h with referen-
ce to the one shown on the display. On the other hand,
if you press “OK” for less than three seconds, the maxi-
mum speed value is increased of 2 km/h with reference
to the one shown on the display.