- 75 -
OPERATION 4
4
EN
Press “OK” for over three seconds to confirm the
selected maximum speed value. The displayed digit
stops blinking and the display returns to “RUN” mode.
On the other hand, if you press “SET” for over three
seconds, the “SPEED LIMITER” function is disabled.
The display shows the “OFF” caption. After three
seconds, the display returns to “RUN” mode.
If the “SPEED LIMITER” function has been enabled,
when riding the vehicle the speed value shown on the
odometer starts blinking when it reaches the set value
of the maximum speed.
To Next Page
Loading...
