Maintenance
- 97 -
B
“UNIT CHANGE” Mode
This function allows for simultaneous editing of the fol-
lowing units of measure:
• Speed
• Distance covered
q Changing the measurement unit
- Access the "SERVICE" mode as described in the pre-
ceding pages, and press the "SET" button for less
than three seconds to until the message "UNIT
CHANGE" appears.
WARNING
The modification or adjustment of display
functions must be carried out with the engi-
ne off and running on neutral, with the
motorcycle stopped with the stands on the
ground. Changing display settings while
running is prohibited.
- Press the "OK " button for less than three seconds
and the unit on the speedometer will begin to flash.
To Next Page
Loading...
