- 80 -
Maintenance
B
“IMMOBILIZER” function
The "IMMOBILIZER" function allows the engine to be
started up only after an original ignition key is recogni-
sed. It is in fact an anti-theft system integrated into the
electronic circuit of the vehicle, since it prevents use by
any unauthorised individuals.
The "IMMOBILIZER" mode on the dashboard must
only be used in case of malfunction. In fact, if for any
reason this system is not able to recognise the code on
the ignition key, you will have to manually enter the
secret code printed on the MV Code Card received
upon delivery of the vehicle to obtain engine start-up
consent.
- Remove the lid from the box on the back of the MV
Code Card and read the secret electronic code of the
starter key (the figure shows a random code, for infor
mation only).
- From "RUN" mode, press the "SET" button for more
than eight seconds to access "IMMOBILIZER" mode.
The display modes may be changed or set
when the engine off, the gear in neutral, the
motorbike stationary with your feet on the
ground. Do not change the display while dri-
ving.
- Press the "OK " button for less than three seconds to
set the first number of the code.
- Press the "OK " button for less than three seconds to
vary the first number value between 0 and 9.
To Next Page
Loading...
