Mychef iCOOK - Errors and Alarms Troubleshooting; Identifying and Resolving Errors

mychefcooking.com
PRODUCT MANUAL iCOOK - DT.MP.IC.2201.2
85
7.8.17. Errors and alarms
During the preparation and execution of any of the programs available in the oven, errors
may occur. If an error occurs in the system during use, it will be displayed in the error list.
The table below shows the different errors and alarms, as well as possible solutions to them.
Error
Internal definition
Notes
0
NO ERROR
No error.
1
ERROR GENERAL PURPOSE
INPUT
General error input. Not used.
2
ERROR OVERTEMPERATURE
General over temperature input. Not used.
3
ERROR OVERTEMPERATURE
PCB
Over temperature PCB. Check that the cooling
fans of the electronics are working properly, that
there is sufficient space between the rear and the
wall, and that the ambient temperature is not too
high.
4.1
ERROR COMMUNICATION
Communication between boards is not
responding. Check the cable connecting the
power board and control board.
4.3
ERROR COMMUNICATION
Communication between relay board and inverter
is not responding. Check the cable connecting
both components. Check if the inverter
communication LED blinks.
4.7
ERROR HOOD
Communication between boards is not
responding. Check the wiring.
4.8
ERROR PROOFER
Communication between boards is not
responding. Check the wiring.
4.9
ERROR STATIC OVEN
Communication between boards is not
responding. Check the wiring.
5
ERROR EEPROM
Communication processor and EEPROM does not
work. Check the control board.
6
ERROR MOTOR
Motor error. Check motor wiring.
Overtemperature on the motor. Motor failure.
7
ALARM WATER
No water detected. Ensure that the water supply is
connected correctly.
8
ERROR WASHING
No detergent detected. Not used.
9
ERROR PROBE1 TEMP SENSOR
NOT CONNECTED
External probe not connected. Check the external
probe and connector.
10
ERROR PROBE1 TEMP SENSOR
SHORTED
External probe short-circuited. Check the external
probe and connector.