PRODUCT MANUAL iCOOK - DT.MP.IC.2201.2
7.8.16. NightWatch
NightWatch allows the oven to automatically continue cooking after a power failure. This
functionality is especially useful for unattended cooking.
This function will only continue with cooking in the event of a power failure
and subsequent recovery of the power supply.
This function can be disabled by your dealer. Make sure that you fully
understand the risks involved in using it.
When a cut occurs and the power supply is subsequently restored, the oven recovers the
current cooking (if any) and continues it with the same parameters prior to cutting.
The following figure shows the oven display when the power is restored and just before
starting NightWatch functionality. Pressing the circular button START/STOP key in this state
will cancel automatic recovery.
If it is not cancelled, the Mychef oven automatically checks the temperature of the cooking
chamber. If the temperature is below 56°C there may be a risk of bacterial contamination.
In this case, the oven will continue cooking but will display error 28 when pressing the
circular button START/STOP button to end the cooking cycle. In this case, the final user shall
decide the fate of the food, taking into account the risks of possible bacterial contamination.
To minimize risks, analyze the food after such a low temperature
warning when it is automatically recovered from cooking, or discard it
(Error 28).
Use the HACCP data record to always check cooking processes.
To Next Page
Loading...