PRODUCT MANUAL iCOOK - DT.MP.IC.2201.2
8.1.4. Plastic outer surfaces and control panel
To clean these more delicate surfaces (support of the control and the control itself) only a
very soft cloth and a cleaning product for delicate surfaces should be used.
Take special care with the control panel, Mychef will not be responsible for
damage caused to this element if it is not cleaned properly.
With regard to the water trap, it allows the drops of water that may fall due to condensation
of the steam from the inner door to go to the drain, for this reason it is important to keep
this water trap clean and unobstructed.
Remove any bits of food that may have fallen before cleaning. Then, clean this piece with a
cloth soaked in water and finally rinse with plenty of water.
8.1.5. Door gasket
Once the chamber cleaning has been completed, the washing process will be followed with
the gasket that ensures the chamber is watertight. It is important that this part of the oven is
clean and does not have any embedded pieces of food so that it can seal the chamber well
and that heat, water or steam cannot escape when it is in operation.
To clean this rubber gasket, just a cloth dampened with soapy water is enough. Then rinse
the entire area and dry well.
The door gasket should not be removed from its contour for cleaning, it should only be
removed when it has to be replaced, in case of replacement it can be done manually without
the help of any tool.
To Next Page
Loading...
