Mychef iCOOK - Page 96

mychefcooking.com
PRODUCT MANUAL iCOOK - DT.MP.IC.2201.2
96
Mychef maintenance program
2000
4000
6000
8000
10000
12000
14000
16000
18000
20000
Review A
Firmware update
X
X
X
X
X
X
X
X
X
X
Water hardness test
X
X
X
X
X
X
X
X
X
X
Cooling fans cleaning of
X
X
X
X
X
X
X
X
X
X
Electronic cleaning
X
X
X
X
X
X
X
X
X
X
Drainage tray and siphon cleaning
X
X
X
X
X
X
X
X
X
X
Changing the gasket and adjusting the door
X
X
X
X
X
X
X
X
X
X
Ionization rated current check *
X
X
X
X
X
X
X
X
X
X
Check that the gas inlet pressure is correct *
X
X
X
X
X
X
X
X
X
X
Control of CO-CO
2
emissions according to model *
X
X
X
X
X
X
X
X
X
X
Check the gas system for leaks *
X
X
X
X
X
X
X
X
X
X
Review B
Pathogen inactivator replacement (depending on models)
X
X
X
X
X
Temperature calibration
X
X
X
X
X
Adjustment of internal screws
X
X
X
X
X
Review C
Change of chimney and drain pipes
X
X
Change of solenoid valve for water injection
X
X
Change of resistance contactor (only models without TSC)
X
X
Review D
Change of motor
X
Change of resistance and gasket
X
Change of internal gaskets
X
Table 11. Periodic maintenance table
*Only gas models
Regular maintenance ensures that your oven always works as designed.
Periodic maintenance must be accredited for warranty validity purposes.
Before any handling for maintenance or repair, the equipment must be
disconnected from the power supply.
If the power cable is damaged, it must be replaced by your service
department or similarly qualified personnel in order to avoid risks.