MZ electronic EV-030 - Standard and X.. Project series sensor menu; 1000-1500-2000 W Project series sensor menu

EV-030 Rev. 07 – 2008
English
41
Once the “Sensor Detection” function has recognised a “Standard” type sensor
instead of a “Project” sensor, when the “Sensor Calibrat.” menu is entered again,
the menu options will “configure” themselves according to the sensor detected.
Standard and X.. Project series
sensor menu
(magnet and sensor placed
on barbotin
)
Sensor Calibrat
Barb. Circ. 33.0
Exit
1000 – 1500 –2000 W Project series
sensor menu
(magnet and sensor placed
on motor
)
Sensor Calibrat
Red. Factor 57.0
Exit
Barbotin Circumference
In this row the user must enter the
circumference of the gipsy (in
centimetres or inches). Use the Table 1
provided to calculate the
circumference.
Settable values: centimetres or inches.
Default value, 33 cm.
Reduction Factor
In this row the user must enter the
reduction factor. See next Table 2 for the
correct value to be entered
Default value, 57.
Select with
Select value with
Confirm with
Exit
To return to the settings menu.
Confirm with