Nabco Acusensor M - Section 8.6: IP Mode (Switches 19 and 20); Chapter 9: Area Adjuster

19 of 28
www.NabcoEntrances.com AcusensorMInstallaonManual
Rev 8-25-17 P/N C-00187
Sensitivity
17 18 Mounting Height
SH
(Super High)
X 98” thru 118” (2.5m thru 3.0m)
X Use if sensivity is too LOW with Switch Seng (H)




IP Mode is ulized when Sensors are placed within the same Area and/or when Sensors are facing each other. This is true for mulple
Acusensor M Sensors and/or older versions of the Acusensor, Acuvision, and/or Acumoon sensors.
To prevent Sensor Malfuncon, the IP Mode Seng must be dierent from that on each other sensor.
Table 18 IP Mode
IP Mode
19 20 Description
A Default for the Acusensor M
B Suggested IP Mode for 2nd Sensor
C Suggested IP Mode for 3rd Sensor
D Suggested IP Mode for 4th Sensor

The Area Adjuster is a Phillips Head screw that the installer turns to angle the Sensor:
X Counter Clockwise to adjust the Detection Area Pattern farther out.
X Clockwise to adjust the Detection Area Pattern farther in.
An Angled Spacer (sold separately) can be used to provide a Presence Detecon Area outside of normal Depth.
1. Turn OFF power.
2. Go to Area Adjuster located on the Right hand side of Acusensor M.
DN 1565
Depth Learn Time Anti-Noise Anti-Environment Sensitivity IP Mode
91011910 11 12 13 14 15 16 17 18 19 20
6 2 30s Normal Normal H A
5 5-6eco 15s Special
Anti-Vibration
M B
4 4-6eco 60s Anti-Snow I L C
3 Area Check 300s Anti-Snow II SH D
Area Adjuster
0
-10
Degree Indicator Charts
Degree Indicator
Area Adjuster
Figure 10 Area Adjuster