GT 710-8710 Swing Door System Low Energy Operator www.NabcoEntrances.com
Part #15-10683 Rev. 9-24-14
3-8 Install the Header
CHAPTER 3: INSTALL THE HEADER
Secon 3a: Inswing Doors
FOR OUTSWING UNITS SKIP TO
SECTION 3B
Open the Swing door 90 degrees.
Measure between the wall and the outside face of the Swing Door.
a. There must be a 2 inch minimum gap.
b. If there is less than a 2 inch gap, please call Customer Service at (877) 622-2694.
Secon 3b: Prepare the Header
a. Protect header from scratches.
Remove two screws from underneath cover. Set Aside. Please see .
Remove Cover by:
X GT710: Lifting it straight off of Header.
X GT8710: Lifting it up from Header, and then pulling it out.
Remove boxes and/or parts bags from inside Header. Set aside.
Cover in Closed Posi on
Swing
UP
to Open
Li UP to
Pull out
Remove Screws
GT 8710 Header
GT 710 Header
Figure 3-1 Remove Cover from Header
3.b.a: Drill Holes in Header (GT 8710)
FOR GT 710 UNITS SKIP TO
SECTION 3C
Go to the Strike side of Header. Drill one 7/8 inch hole through the Header to allow all wiring to
be drawn inside.
a. The GT-8710 Header can be ordered with a Knockout hole located at either end of the
Header. For details, please call Customer Service at 1-888-679-3319.
Go to the back wall inside Header on the Pivot side. Please see .
To Next Page
Loading...
Need help?
General
