NAD C375BEE - Specifications

REFERENCE
SPECIFICATIONS
LINE LEVEL INPUT, PRE OUT
THD (2 Vin 2 Vout, CCIF IMD, DIM 100)
Signal/Noise ratio IHF
Channel separation - 1 kHz
10kHz
Input impedance
(R and C)
Maximum input signal
Output impedance - Pre out
Variable out
Tape out
Input sensitivity
Frequency response
Maximum voltage output -IHF load
600 ohms load
TONE CONTROLS
Treble
Bass
MAIN IN, SPEAKER OUT
Continuous output power into 80 and 4 0 (Stereo)
Continuous output power into B0 (Mono, Bridge mode)
Rated THD (CCIF IMD, DIM 100)
Clipping power
IHF dynamic power - 8 0
40
20
IHF dynamic power (Bridge mode) - B0
40
Peak output current
Signal/noise ratio
Damping factor
Frequency response
Input impedance
Input sensitivity
Voltage gain
Headphone output impedance
Channel separation - 1 kHz
10 kHz
TRIGGER OUT
Output resistance
Output current
Output voltage
14
>0.004 % (ref. 20 Hz - 20 kHz)
>1 02 dB (A-weighted, ref. 500 mV)
> 11 0 dB (A-weighted, ref. 2V, Volume maximum)
>92 dB (A-weighted, ref. 100 mV in 100 mV out - unity gain)
>80dB
>70dB
100 kO+ 320 pF
>8 Vrms (ref. 0 1 THD)
750
<3250
Source Z+ 1 kO
158 mV (ref. 500 mV out)
± 0.1 dB (ref. 20 Hz - 20 kHz, Tone defeat ON)
± 05 dB (ref. 20 Hz - 20 kHz, Tone defeat OFF)
>10V (ref. 0.03% THD)
>10V (ref. 0.03% THD)
± 5 dB at 10 kHz
±8dBat 100Hz
>150W
(ref. ratedTHD, 20 Hz-20 kHz, both channels driven)
>330W
<0.009 % (ref. 20 Hz - 20 kHz)
>170W(ref.1 kHz l%THD)
250W
410W
600W
BOOW
1200W
>50 A (ref. 10, 1 ms)
>1 02 dB (A-weighted, ref. 1 W)
> 123 dB (A-weighted, ref. 150 W)
>200 (ref. 80, 50 Hz and 1 kHz)
± 0.1 dB (ref. 20 Hz - 20 kHz)
3 Hz - 70 kHz (ref. -3 dB)
10 kO + 200 pF
1.2 V (ref. rated power)
29dB
680
>B5 dB
>75 dB
<1200
50mA
+12V