To remove the auto-enter, please read the code “disable suffix” on page 28.
Q6. Why does scanner not read the first digit of UPCE barcode.
Answer:
The first digit of UPCE barcode is system charater. The scanner does not output the
system character by default.
To enable the scanner to read the first digit of UPCE, read the code “ Show UPCE
system digit”on page 30.
Q7. How to add TAB?
Answer:
To add TAB, read the code “TAB” on page 28.
Q8. Can the scanner send two enter after every scanning?
Answer:
To add two enter, please read these codes in order.
“Insert character” (on page 34)
“All barcode type” (on page 34)
“Data group 1” (on page 35)
“After barcode” (on page 37)
“013 CR/ENTER” (on page 41)
“013 CR/ENTER” (on page 41)
“Save settings” (on page 38)
To Next Page
Loading...
