3. 2.4GHz Wireless Mode Pairing Setting
In 2.4GHz wireless mode, two kinds of pairing modes are supported.
3.1 One scanner to one receiver：One scanner only sends barcode to one receiver.
Pairing operation:
Plug the USB receiver into your computer , scan the code "match " to pair the scanner
with the USB receiver
Pairing indication:
（1）If the pairing succeeds, the buzzer beeps "DI-en""di di di"
（2）If the pairing faileds, the buzzer beeps "DI---en"
NOTE：30 seconds after the USB receiver is inserted, the scanner cannot match the USB
receiver. If the pairing failed, please unplug the USB receiver and plug it again, then
scan the code "match".
To Next Page
Loading...
