72
Pin
No.
Code
Function
Input /
Output
Description
8 ERR Error
Output
OFF (Open) : Error
ON (Closed) : Normal
Output shows that error has occurred.
Error code will be displayed on Digital
Speed Indicator.
When setting parameter
, Error
Output Mode can be changed. (Refer
to P90 " 18 - 4 ①
Setting of Error
Output Mode " section.)
9 Not used
――
― *Note : Never use pin labeled " NOT
USED "
10 GND Internal GND
for Motor
Speed Control
Voltage
Output
Internal CONTROLLER
GND
This GND will be used for " Motor Speed
Control Voltage (VR) ".
Output DC+10V
11 Vcc Internal Power
Source for
Motor Speed
Control Voltage
Output
Internal Power : DC+10V Internal Power Source for " Motor Speed
Control Voltage (VR) ".
1
2 MOTOR_I Motor Current
Monitor
Output
0V ≦ MOTOR_I ≦ 10V
DC 0V : 0Amp
DC+10V : 20Amp
Output Motor Current Monitor with Analog
Monitor Voltage.
2Amp / 1V. Max. 20Amp.
13 GND Internal GND
for Analog
Monitor
Output
Internal CONTROLLER
GND
This GND will be used for analog monitor.
(MOTOR_I, SPEED_V, and LOAD).
14 START Rotate
Command
Input
OFF (Open) : Stop
ON (Closed) : Start
Motor Start and Motor Stop Signal
Setting
parameter
, can start with
forward rotation. (Refer to P93 " 18 - 4
⑥
Selection of External Motor Start
Signal Control Mode " section.)
15 UD_IN
UP / DOWN
Signal for
Setting Motor
Speed
Input
OFF (Open) : Speed Down
ON (Closed) : Speed Up
This signal is for increasing and
decreasing the desired speed by the use
of a Pulse Signal. Whether it increases or
decreases speed is determined by
CNT_
IN. It is requred that parameter
.
(Refer to P92 " 18 - 4 ⑤ Selection of
External Speed Control Mode " section.)
16 500min
-1
(rpm)
Rotates Motor
at " Centering "
speed
Input
OFF (Open) :
Normal Operation
ON (Closed) :
500min
-1
(rpm)
Set motor rotation speed is 500 min
-1
(rpm).
Use the Centering Mode.
17 SEL0 Speed Point
Select 0
Input
OFF (Open)
ON (Closed)
Speed Point (
- ) can be
Selected using a SEL0 and SEL1 signal
combination. P70 " 15 - 2 - 2 (4) ③ Set by
the Speed Point Signal Table 3 " section.
Need to set parameter
. (Refer to
P92 " 18 - 4 ⑤
Selection of External
Speed Control Mode
"
section.)
To Next Page
