Nakanishi E4000 CONTROLLER User Manual

51
English
1. CAUTIONS FOR HANDLING AND OPERATION
■ Read these warnings and cautions carefully and only use in the manner intended.
■ These warnings and cautions are intended to avoid potential hazards that could result in personal injury to the
operator or damage to the device. These are classi¿ed as follows in accordance with the seriousness of the risk.
Class Degree of Risk
DANGER
Existence of a hazard that could result in personal death or serious
injury, if the safety precautions are not followed.
WARNING
A safety hazard could result in bodily injury or damage to the device if
the safety instructions are not properly followed.
CAUTION
A hazard that could result in light or moderate bodily injury or damage
to the device if the safety instructions are not followed.
① NAKANISHI warns all end-users not to remove the Power Cord, Motor Cord, Protective Covers
A and B or Options while the Control Power is ON, or if there is power to the main power cord.
Disconnect the main power from its power source before removing the Power Co
rd, Motor
Cord, Protective Covers A and B or Options. Not following these instructions may lead to
serious injury or death due to electric shock.
② Attach the Protective Covers A and B before use. Touching a power terminal connection by
mistake may cause risk that leads to death or serious injury by electric shock.
③ Make sure the input power supply is OFF before wiring. If the incoming power supply is ON, it
may cause risk that leads to death or serious injury by electric shock
④ Be sure to connect the ground wire to the earth ground. Insuf¿cient grounding could cause an
electric shock or malfunction.
⑤ Be sure to connect the ground wire of the Power cord to the AC Input Power Terminal Block
(Earth Mark). Insuf¿cient grounding could cause an electric shock or ¿re and malfunction.
Thank you for purchasing the E4000 Ultra-Precision, High-Speed spindle system.
The E4000 system was designed for use on CNC lathes and mills, robots, NC lathes and special purpose
machines. This system utilizes air to cool the motor and purge the spindle.
Please use an NAKANISHI Air Line Kit to ensure clean, dry, properly regulated air is supplied to the motor and
spindle. The E4000 system is capabl
e of being used with coolants and cutting lubricants.
Please read this Operation Manual carefully before use. Also read <Brushless Motor>, <Spindle> and <Air Line Kit>
Operation Manuals.
Always keep this Operation Manual in a place where a user can referred to for reference at any time.
DANGER
① The CONTROLLER is not a hand tool. It is designed to be used on a CNC lathe or special
purpose machines.
② Do not touch the cutting tool while the spindle and tool are rotating. It is very dangerous.
③ Wear safety glasses, dust mask, and use a protective cover around the spindle whenever the
spindle is rotating.
④ Never connect, disconnect or touch the Power Cord and Motor Cord Plug with wet hands. This
may cause an electric shock.
⑤ Never operate or handle the CONTROLLER and motor or spindle until you have thoroughly
read the owner's manual for each component, and safe operation has been con¿rmed.
1) To prevent injuries / damages, check the CONTROLLER, motor, spindle and cutting tool for
proper installation, then operate the CONTROLLER, motor and spindle.
2) Before disconnecting the CONTROLLER,
motor or spindle, always turn the control power
OFF and turn the compressed air supply to the CONTROLLER OFF. Then it is safe to remove
the CONTROLLER, motor and spindle.
WARNING

Nakanishi E4000 CONTROLLER Specifications

General

Brand	Nakanishi
Model	E4000 CONTROLLER
Category	Controller
Language	English