NANO D2 Series - General Information; Document Introduction; Support & Manufacturing Details

Page 4
1. GENERAL INFORMATION
This manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied, reproduced,
translated, or reduced to any electronic medium or machine readable form without prior consent in wring from
nano-porous soluons. It may not be distributed through the internet or computer bullen board systems without
prior consent from nano-porous soluons limited.
IMI Precision Engineering
nano-porous soluons limited
Dukesway,
Team Valley Trading Estate,
Gateshead NE11 0PZ.
Tel: +44 (0) 1543 265 000
www.imi-precision.com
1.2 Support and Manufacturers Details
NOTES: highlight important secons of informaon where parcular care and aenon should be paid.
CAUTIONS: indicate any situaon or operaon that may result in potenal damage to the product,
injury to the user, or render the product unsafe.
Annotaons:
1.1 Document Introducon
This manual provides factory prescribed installaon and maintenance procedures for a nano-porous soluons D2
Series compressed air dryer. The procedures illustrated in this document are only to be performed by fully trained
competent authorised personnel. For further informaon regarding the procedures outlined in this document
contact nano-porous soluons before proceeding.
Read this document carefully before aempng to install or operate the dryer. This document should be
permanently available at the dryer installaon site and be kept in an easily accessible place alongside the dryer.
©2015 Nano-porous soluons
Product: D2 Series - Heatless Compressed Air Dryer
Models: NDL-060, 070, 080, 090, 100, 110, 120, 130 (Including ES Model)
Doc no: 17-100-0121
Issue: 001