To Next PageTo Next PageWhat to do if Napoleon BL46NTE pilot sparks but won't light?
If the pilot sparks but won't light on your Napoleon Indoor Fireplace, it may be an issue with the gas supply. Contact a qualified technician to inspect the gas supply. Also, check if you are out of propane gas and fill the tank if necessary.
How to reset Napoleon BL46NTE remote control?
If the remote control for your Napoleon Indoor Fireplace is not functioning properly, reset the program by holding the reset button on the remote control until you hear two beeps, then release it. Within 20 seconds, press the small flame button on the remote; you should hear another beep indicating a successful reset. If this doesn't work, consider replacing the remote control.
What to do if my Napoleon Indoor Fireplace smells of exhaust fumes and causes headaches?
If your Napoleon Indoor Fireplace is emitting exhaust fumes and causing headaches, it may be leaking exhaust into the room. First, check that the firebox glass door was properly reinstalled after cleaning. If the issue persists, immediately turn off the appliance and contact a qualified technician.
What to do if my Napoleon BL46NTE won’t perform any functions?
If your Napoleon Indoor Fireplace isn't performing any functions, first check that the breaker is in the 'on' position to ensure the system has power. If equipped with a battery holder, verify that the 3-position switch is in the remote position (middle). Also, check the battery power and battery orientation in the battery holder and remote control to ensure they are operational.
What to do if I have an error with synchronizing my Napoleon BL46NTE?
If you are experiencing an error with synchronizing your Napoleon Indoor Fireplace, reset the battery holder (including switch) and remote control.
What to do if my Napoleon Indoor Fireplace battery holder (including switch) or remote has low battery?
If your Napoleon Indoor Fireplace's remote control or battery holder has a low battery, replace the batteries.
What causes a Napoleon Indoor Fireplace battery holder (including switch) to be mounted upside down?
If your Napoleon Indoor Fireplace's battery holder (including switch) is mounted upside down, it could be due to the battery holder (including switch) and/or wire grounding, or a faulty wire. Check for a ground (short), repair the ground or replace the wire. If there is a faulty wire, replace it.
Why is the flame on my Napoleon BL46NTE blue, lazy, and transparent?
If the flame on your Napoleon Indoor Fireplace is blue, lazy, and transparent, there might be a blockage in the vent. Remove any blockage. In very cold conditions, ice buildup may occur on the terminal and should be removed as needed.
Why does a white/grey film form on the glass of my Napoleon BL46NTE Indoor Fireplace?
If a white or grey film forms on the glass of your Napoleon Indoor Fireplace, it is likely sulphur from the fuel being deposited. Clean the glass with a recommended gas fireplace glass cleaner, ensuring the glass is not hot. Regular cleaning prevents permanent marking.
How to reset remote lockout on Napoleon BL46NTE?
If your Napoleon Indoor Fireplace's remote control lights up but there is no spark or flame, it may be locked out. Reset it by turning the power source off, then on again.
General| Type | Direct Vent Gas Fireplace |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Vent Type | Direct Vent |
| Ignition | Electronic Ignition |
| Efficiency | 80% |
| Control Type | Remote Control |
| BTU | 26, 000 BTU/h |
| Venting | Direct Vent |
Warnings about potential fire and explosion risks.
Procedures to follow if gas is detected.
General safety warnings and precautions.
Provides a step-by-step overview of the installation process.
Detailed dimensions for the BL36-1 model.
Detailed dimensions for the BL46 model.
Critical safety warnings related to venting installation.
Illustrates standard venting configurations.
Specifies minimum clearances for vent terminal locations.
Guidelines for horizontal vent termination.
Guidelines for vertical vent termination.
Critical safety warnings related to rough framing.
Specifies minimum framing dimensions for installation.
Critical safety warnings related to venting installation.
Installation procedures for horizontal venting.
Installation procedures for vertical venting.
Procedures for vertical venting through an existing chimney.
Critical safety warnings for chimney installations.
Covers hardwiring, receptacle, and general diagrams.
Critical electrical safety warnings.
Critical safety warnings for battery backup installation.
Provides the main wiring diagram for the appliance.
Critical warning regarding wiring connections.
Critical safety warnings for gas installation.
Critical safety warnings before operating the appliance.
Details the President's Lifetime Limited Warranty for gas appliances.
