Index
© National Instruments Corporation I-3 cFP-20xx and cFP-BP-x User Manual
powering, 2-16
removing, 2-14, 2-15, 3-2
replacing, 3-2
installation
category, 2-3
connecting to network, 2-16
FieldPoint software, 2-18
hot swapping, 3-2
installing cFP-20xx controller on
backplane, 2-13
installing I/O modules on backplane,
2-13, 2-15
LabVIEW RT, 2-18
mounting hardware in rack
mounting backplane, 2-8
rack-mount accessory, 2-8
figures, 2-9
mounting hardware on DIN rail
fastening DIN rail clip to
backplane, 2-11
mounting backplane on DIN
rail, 2-11
mounting hardware on panel
cFP-20xx mounting procedure, 2-6
panel-mount accessory, 2-6
mounting hardware to panel
panel-mount accessory
figure, 2-7
overview, 1-3
power connections, 2-16
removing I/O modules, 2-14, 2-15
Installer Settings tab in Application
Builder, 4-11
instrument drivers (NI resources), C-1
IP address
resetting with Reset switch, 3-6
isolation
defeated by cascading power
(caution), 2-17
K
KnowledgeBase, C-1
L
LabVIEW RT
See also Application Builder
disabling engine with Safe Mode
switch, 3-6
embedded applications. See embedded
applications on cFP-20xx
network options, 4-3
programming, 4-1
RT Engine, 1-1, 3-6, 3-11, 4-3, 4-8
RT Target Access options, 4-4
RT Target Miscellaneous options, 4-6
targeting LabVIEW RT
to a platform, 4-1
to host PC, 4-3
LabVIEW VIs
Disable VI switch, 3-6
embedded applications. See embedded
applications on cFP-20xx
FieldPoint VIs, 5-1
launching VIs at system startup, 4-6, 4-11
Publish Data VI, 5-5
runaway startup applications, A-1
serial VIs, 5-6
specifying download path, 4-6
specifying target with command line
arguments, 4-8
TCP, 5-6
UDP VIs, 5-6
LabWindows/CVI software, 5-1
LED indicators, 1-2, 2-5, 2-13, 3-3
power-on self test (POST), 2-17, 3-4
LED output, 3-9, 3-10
LINK LED, 3-3
local bus connector, 1-2, 2-5, 2-13
To Next Page
Loading...
