National Instruments DAQ Series - Power Requirement; Physical; Maximum Working Voltage

Appendix A Specifications
DAQCard-700 User Manual A-4 ni.com
Base clocks available..............................1 MHz
Base clock accuracy................................±0.01%
Max source frequency.............................10 MHz
Min source pulse duration ......................50 ns
Min gate pulse duration ..........................50 ns
Data transfers..........................................Programmed I/O
Bus Interface
Type ........................................................slave
Power Requirement
+5 VDC (±5%) .......................................100 mA in operational mode
70 mA in power-down mode
Note
These power usage figures do not include the power used by external devices that
you have connected to the fused supply present on the I/O connector.
Physical
PC Card type...........................................Type II
I/O connector ..........................................50-pin male
Maximum Working Voltage
Maximum working voltage refers to the signal voltage plus the
common-mode voltage.
Channel-to-earth .....................................30 VAC or 60 VDC, installation
category I
Channel-to-channel.................................30 VAC or 60 VDC, installation
category I
Environmental
Operating temperature ............................0 to 70 °C
Storage temperature................................–55 to 150 °C