26 | ni.com | NI myDAQ User Guide
Example: Measuring a Signal Using the NI ELVISmx
Oscilloscope with NI myDAQ
Complete the following steps to measure a signal with the NI ELVISmx Scope.
Note Before opening an NI ELVISmx software instrument, make sure that the
myDAQ device is connected to the system and is ready to use. After the myDAQ is
connected to the system, the blue LED by the connector lights, indicating the device
is ready for use.
1. Connect the signal(s) you want to measure to the connector(s) on the side of the NI myDAQ
device.
2. Launch the NI ELVISmx Scope from the NI ELVISmx Instrument Launcher.
3. Click Run. You should see the signal in the Display Window.
4. If necessary, adjust the controls to stabilize the signal in the graph. Adjust the Time/Div,
Vertical Position, Scale, and other controls as desired.
To Next Page
Loading...
Need help?
General