NI myDAQ User Guide | © National Instruments | 35
Resource Conflicts
Table 6 summarizes the resource conflicts you might encounter if you run certain NI myDAQ
circuitry simultaneously.
To use the information in Table 6, find the instrument you want to use in the left column. That
row lists all the functions that are resource conflicts. If the intersecting box contains an —, you
can use those functions simultaneously without any conflicts.
Tristate Buffer SN74AHCT1G125 This is a single bus buffer gate/line driver with
three-state output.
Voltage Supervisor TPS3809 This is a supervisory circuit that provides circuit
initialization and timing supervision, primarily for
DSPs and processor-based systems.
Comparator TLV3491 This is a push-pull output comparator that features a
fast 6 µs response time and <1.2 µA (max) nanopower
capability, allowing operation from 1.8 V-5.5 V.
Operational Amplifier TLE2082 This is an operational amplifier more than double the
bandwidth and triple the slew rate of the TL07x and
TL08x families of BiFET operational amplifiers.
Operational Amplifier OPA1642 This is a JFET-input, ultra-low distortion, low-noise
operational amplifier, fully specified for audio
applications.
Audio Amplifier TPA6110A2 This is a stereo audio power amplifier packaged in an
eight-pin PowerPAD
™
MSOP package capable of
delivering 150 mW of continuous RMS power per
channel into 16 Ω-loads.
Buffer SN74AUP1G17 This is a low-power Schmitt-Trigger buffer.
Switch TS12A44514 This is a low on-state resistance quad SPST CMOS
analog switch.
Table 5. Texas Instruments Components in NI myDAQ (Continued)
Texas Instruments
Integrated Circuit
(IC)
Part Number Description
To Next Page
Loading...
Need help?
General