The modulation amount for controller targets can be set by the corresponding faders. Slid
ing the fader to the right causes positive, sliding it to the left, negative modulation
amounts. This means that for positive modulation amounts the target parameter is in
creased as the Macro Controller is increased in value. For negative modulation amounts
the target parameter would be reduced as the Macro Controller is increased in value.
5.3.1 PRISM – Modulation Targets for Each Controller
MC1/MC2 First Controller Modula
tion List
MC1/MC2 Second Controller Modu
lation List
MC1/MC2 Third Controller Modu
lation List
Exc: Env A Exc: Env R Exc: Impulse
Exc: Noise Exc: FB Exc: Ext FB
Exc: Timer Exc: Max Exc: Lo Cut
Exc: Hi Cut Modal: Bend Modal: Multi
Modal: HP Modal: HP Slope Modal: Release
Modal: Time Modal: Hi Amt Modal: Cutoff
Modal: Fund Modal: A Modal: B
Modal: Shift Modal: A/B Bal Modal: RM
VDelay: Time VDelay: Phase Modal: 2nd H
Mixer: Sat Mixer: Exciter Mixer: Delay
Mixer: Sum Mixer: Sum Mixer: Sum
LFO: Rate LFO: Amount 1 LFO: Amount 2
Cabinet: Drive Cabinet: Tilt Cabinet: Mix
Cabinet: Level Cabinet: Hi Cut 8P Filter: Center
8P Filter: LR 8P Filter: Gap 8P Filter: Mix
8P Filter: Balance 8P Filter: Reso Flanger: Time
Flanger: FB Flanger: Rate Flanger: Depth
Flanger: Mix Echo: Time Echo: LR
Overview of REAKTOR PRISM Ensemble
Macro Controller Section
REAKTOR PRISM - Manual - 20
To Next Page
Loading...
Need help?
General
