Native Instruments Reaktor Prism User Manual

[3] LR OFFSET: Sets the ratio between the delay times of the left and of the right channel
(value is offset to 1.0). In center position, both delay times are equal.
[4] MIX: Crossfades between the dry signal and the delayed signal.
[5] LO CUT: Cutoff frequency (in Hz) of the filter that damps the lower frequencies of the
delayed signal.
[6] HI CUT: Cutoff frequency (in Hz) of the filter that damps the higher frequencies of the
delayed signal.
[7] FB: Amount of feedback from the delay output to its input.
5.12.5 Reverb
Use this high quality Reverberation unit to add more spatial depth to your sound.
Reverb Parameters
Fig. 5.16 Reverb from the Effects section
▪
[1] SIZE: The room size and reverb time are set here.
▪
[2] MIX: Crossfades between the dry signal and the reverberation signal.
▪
[3] LO CUT: Cutoff of the filter that damps the lower frequencies of the reverberation sig
nal.
▪
[4] HI CUT: Cutoff of the filter that damps the higher frequencies of the reverberation
signal.
Overview of REAKTOR PRISM Ensemble
Effects Section
REAKTOR PRISM - Manual - 44

Native Instruments Reaktor Prism Specifications

General

Brand	Native Instruments
Model	Reaktor Prism
Category	Software
Language	English