Please refer to the documentation provided with Cubase SX / Nuendo for more information on
setting up MIDI for virtual instruments and effects. You may also find more support and infor
mation specific to your scenario on the Native Instruments REAKTOR website forum.
6.4.4 FL Studio
In FL Studio, add REAKTOR PRISM FX as an insert to the channel you want to process. In
the plug-in window, on the arrow next to the folder icon on the left in the header, select
Show MIDI Port from the drop-down. A new green area appears on the right of the plug-in
wrapper’s header. Drag on this area to select a specific port number. From FL’s main
menu select
Channels > Add one > MIDI Out. On the MIDI Out instrument, select the same
port you used for the plug-in. You can now send MIDI on from the MIDI out instrument’s
track to the plug-in.
Please refer to the documentation provided with FL Studio for more information on setting up
MIDI for virtual instruments and effects. You may also find more support and information spe
cific to your scenario on the Native Instruments REAKTOR website forum.
6.4.5 ProTools 8
Create one MIDI or audio channel with the REAKTOR PRISM FX used as an insert. Create
a second track for the incoming MIDI. In the new MIDI track’s Input/output section on the
mixer, select REAKTOR PRISM FX. Now make sure you are recording on the new MIDI
track (or use monitor to send MIDI always).
Please refer to the documentation provided with ProTools 8 for more information on setting up
MIDI for virtual instruments and effects. You may also find more support and information spe
cific to your scenario on the Native Instruments REAKTOR website forum.
Overview of the REAKTOR PRISM FX Interface
Sending MIDI to REAKTOR PRISM FX
REAKTOR PRISM - Manual - 57
To Next Page
Loading...
Need help?
General
