Dantec Keypoint Focus
9
The use of accessories, electrodes, and cables other than those specified by Natus may result
in increased emissions, or decreased immunity of the equipment.
Use only optional devices specified by Natus in order to comply with IEC 60601-1.
When connecting other equipment, attention must be paid to standard: IEC 60601-1 Medical
Electrical Equipment, (Part 1…). Failure to comply with this standard may result in safety risk.
The equipment should not be used adjacent, or stacked with other equipment. If adjacent or
stacked use is necessary, the equipment should be observed to verify normal operation in the
configuration in which it will be used.
Dangerous physiological effects! The current stimulator may give off dangerous currents and
voltage.
When operating the current stimulators, be careful not to expose patients to high currents.
Before connecting or disconnecting the stimulation electrode, always “reset” the stimulator.
Pay attention to the intensity indicator during the use of the program. –See the section
Stimulator Overload in the software user guide, and the section Stimulators in this hardware
manual for further information.
Electrostatic Sensitive Amplifier Input connectors – Do not touch the Amplifier Input
connectors as it may damage the amplifier, or affect its performance.
Cautions
Always use shielded power line cables from Natus to avoid hum line interference, especially
near the patient, or the amplifier.
Portable and mobile RF communication equipment can affect electrical equipment for medical
use.
Electric shock hazard. Do not remove the cover. Refer servicing to qualified service personnel.
Avoid accidental contact between connected, but unapplied electrodes and other conductive
parts - including those connected to protective earth.
Do not use cleaning detergents, or other cleaning agents based on alcohol, solvent, silicon-
based, abrasive and/or flammable substances to clean the equipment.
Side Effects
There are no known side effects for procedures performed with Keypoint Focus.
To Next Page
Loading...
