Nautilus T624 Service Manual

156
12. Using a 6mm hex wrench, remove the hardware from the Left Upright.
Be prepared to support the Upright when the hardware is removed.
13. Using a 6mm hex wrench, remove the hardware from the Right Up-
right. Slightly remove the Right Upright from the Base Assembly exposing
the Input/Output (I./O) Cables. Disconnect the I/O Cables and remove the
Right Upright.
Note: do not crimp cables.
B
F
X4
A
F
X4
E
E
B
F
X4
A
F
X4
E
E
14.Makesurethereissufcientspacetolowerthewalkingdeck.
Keep a minimum clearance behind the machine of 2 m (79”) and
0.6 m (24”) on each side. This is the recommended safe distance
for access, movement and emergency dismounts from the
machine.
15.Makesurethereisnoobjectonoraroundthetreadmilltospillor
cause blockage from the fully unfolded position.
16. Slightly push the walking deck forward toward the console. With your
foot lightly push the top part of the hydraulic lift forward until the locking
tube releases and you can pull the walking deck away from the con-
sole. Hold up the rear of the walking deck, and move to the side of the
machine.
Keep clear of the movement path of the walking deck.
17. The hydraulic lift is set up to drop gradually. Hold onto the walking
deck until approximately 2/3 of the movement down. Make sure that
you use proper lifting technique; bend your knees and keep your back
straight. Be aware that the walking deck can possibly drop quickly in the
last part of the movement.

Nautilus T624 Specifications

General

Quantity per pack	1 pc(s)
Foldable	Yes
Bluetooth	No
Incline range	0 - 12 %
Maximum speed	19.3 km/h
Minimum speed	0 km/h
Product color	Black, Grey
Number of programs	22
Maximum user weight	136 kg
Backlight color	Blue

Weight and Dimensions

Width	- mm
Weight	- g
Running area (W x L)	20 x 55 mm
Running belt thickness	1.5 mm
Running deck thickness	19 mm