NAUTILUS
®
GETTING STARTED
CHANGING THE GAME IN HEALTH AND FITNESS
®
8
GETTING STARTED
Magnetic Safety Stop Activation
To activate the limited-access control and restrict access, place the magnetic
safety stop cord supplied with the treadmill in the designated area located
below the display.
The magnet will activate the control. If you remove the key, the treadmill belt
will stop and the controller will not respond to any key presses. Accumulated
values will remain on the display until you turn off the power, or press [Clear].
The console will display a message, REPLACE MAGNET when you remove the
magnetic key from its designated area. You must replace the key or deactivate
the control to start the walk belt.
Guidelines For Getting On and Off the Treadmill
Instruct each user in the following guidelines for getting on and off the
treadmill.
1. The walking belt should be moving at minimum speed before the user steps onto the
treadmill.
2. Stand next to the treadmill and place both hands on the front handrail.
3. Straddle the walking belt or step onto the side of the deck. Step onto the moving belt
and begin walking.
4. (Optional) To get the feel of the moving belt place the foot nearest the treadmill on
the walking belt and let it move backwards. Lift it and repeat
several times until comfortable with the treadmill speed.
5. When walking comfortably on the treadmill, let go of the
handrail.
6. While walking on the treadmill:
• Face forward. Avoid looking down at the walking belt.
• Maintain speed by keeping a consistent distance from the
handrail.
• Adjust the speed and incline as desired. Hold the handrail
as the speed and incline change.
7. Before stepping off the treadmill, place one hand on the
handrail, wait for the belt to stop, then step off.
Attach magnetic safety cord onto
clothing as shown.
To Next Page
Loading...
Need help?
General