14
9. Install Water Bottle Holder
Note: The hardware(*) is pre-installed on the Console Mast and not on Hardware Card.
*
X2
14
10. Connect Power Cord
Connect this machine to a properly earthed outlet only (see Earthing Instructions).
11. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Be sure to record the serial number in the field provided at the front of this manual.
!
Do not use or put the machine into service until the machine has been fully assembled and inspected for
correct performance in accordance with the Owner’s Manual.
15
To Next Page
Loading...
