NCR RealPOS 5976-1 Series - Chapter 8: Service Support Utility; Introduction

Chapter 8: Service Support Utility
Introduction
The Service Support Utility configures the following settings of the NCR 5976 Line
Display device:
NCR5976LDServiceSupport
Flash Firmware

Flash Additional Code Page

Replace Existing Code Page

Generate Code Page

Set Brightness Level

Shift Firmware

Windows

Linux

Remarks
• Automatic firmware flashing and code page
flashing
• Automatic firmware shift
• Automatic brightness setting to one of the
following levels: 20%, 40%, 60%, 80%, 100%
Note: You can configure the device using the default firmware and code page
settings. For more information, refer to the “Control the Service” section in this
chapter.
Note: For generating code page, please see the document 5976 LD Service Support
Batch Update Guide.doc and refer to section “Place Firmware and Code Page Files” for
instructions. The document is available from the NCR 5976 LD Support page
http://www5.ncr.com/support/support_drivers_patches.asp?Class=External/PeripheralsLineD
isplay5976\display
8