NCR RealPOS 5976-1 Series - Retail Display Commands

5-2 Chapter 5: Programming
Retail Display Commands
The following table describes the Retail Display commands supported:
Command Function
1B 01
Reset Display
1B 02
Erase Display
1B 03
Invalid Command
1B 04
Set Diagnostic State
1B 05
Set Display State On
1B 06
Set Low Power State On (Default)
1B 07
Enable Cursor
1B 08
Disable Cursor (Default)
1B 09
Set Screen Save Blank (Default)
1B 0A
Set Screen Save Walk
1B 0B
Turn On Screen Save
1B 0C
Disable Screen Save Feature
1B 0D
Enable Character Blink
1B 0E
Disable Character Blink (Default)
1B 0F
Move Cursor Left
1B 10
Move Cursor Right
1B 11
Move Cursor Up
1B 12
Move Cursor Down
1B 13
Set Cursor Position
1B 14
Query All Character Set Code Name
1B 17
Brightness Adjustment (Default = 2)
1B 18
Read Display ID
1B 19
Read Display ID String
1B 1B
Display ESC Character
1B 20
Select Character Set 1 (Default)
1B 21
Select Character Set 2
1B 22
Select Character Set 3