NCR RealPOS 5976-1 Series - Using the Default Settings

Chapter 8: Service Support Utility 8-12
Using the Default Settings
Note: This feature is supported in versions 1.1 or higher.
To use the default settings for Windows or Linux, perform either of the following
steps.
Windows
1. Locate the 5976LDSettings folder in your Windows directory.
2. Open the
Settings.ini file.
3. Change the value of UseDefault to True.
Note: To revert to the user–defined settings, simply set the value to False.
Linux
1. Locate the /usr/local/5976LDSettings folder in your Linux directory.
2. Open the
Settings.ini file.
3. Change the value of UseDefault to True.
Note: To revert to the user–defined settings, simply set the value to False.