3-4 Chapter 3: Hardware Installation
7. Connect the display to the post assembly
8. Connect the terminal end of the Display Cable to the host terminal.
• RS–232 Interface (Powered)
Connect the I/F cable to a powered RS–232 connector on the terminal.
• RS–232 Interface (Non–Powered)
Connect the I/F cable to a non–powered RS–232 connector on the terminal.
Connect a Power Brick to the I/F cable and an AC outlet.
Configure the terminal serial port as follows:
9600 baud, 8 data bits, 1 start bit, 1 stop bit, No parity
22934
9-pin 1 connector
(DB9)
Host
Plug AC Power
Adapter into Pod
To Next Page
Loading...
