NCR RealPOS XR6 - USB Configuration

BIOS Setup 4-93
SMART Status N/A
► USB Configuration
Legacy USB Support [Enabled]
XHCI Hand-off [Enabled]
EHCI Hand-off [Disabled]
Port 60/64 Emulation [Enabled]
USB hardware delays and time-outs:
USB transfer time-out [20 sec]
Device reset time-out [20 sec]
Device power-up delay [Auto]
► Info Report Configuration
Summary Screen [Disabled]
► SMART Settings
SMART Self Test [Disabled]
► System Super IO Configuratoin
. ►Serial Port 1/A Configuration
. Serial Port [Enabled]
. Device Settings IO=3F8h; IRQ=4;
. I/O Base Address [0x3F8]
. IRQ [IRQ4]
. ►Serial Port 2/B Configuration
. Serial Port [Enabled]
. Device Settings IO=2F8h; IRQ=3;
. I/O Base Address [0x2F8]
. IRQ [IRQ3]
. Device Mode [Standard Serial Po. . .]
. ►Serial Port 3/C Configuration
. Serial Port [Enabled]
. Device Settings IO=3E8h; IRQ=11;
. I/O Base Address [0x3E8]