2 - 9
Serial Port Connection
All communication parameters between the scanner and terminal must match
for correct data transfer through the serial port using RS-232 protocol.
Scanning the RS-232 interface bar code, programs the scanner for an RS-232
interface at 9600 baud, even parity, 7 data bits, 1 stop bit (8 bit data), and adds
a suffix of a CR LF.
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to
the scanner.
Note: For the scanner to work properly, you
must have the correct cable for your type
of terminal/computer.
3. Plug the serial connector into the serial port on the back of your computer/
terminal, as shown below. Tighten the two screws to secure the connector
to the port.
4. Plug the power pack into a power source.
5. Once the scanner has been fully connected, power up the terminal/com-
puter.
RS-232 Interface
2
3
To Next Page
Loading...
