6 - 2
RS-232 programmable selections are used by both the primary and secondary
interfaces. Changing an RS-232 parameter (e.g., baud rate or parity), while in
primary
or
secondary mode will affect both interfaces.
Secondary Non Decoded Output Laser Emulation
Use this selection when connecting to a secondary terminal with integral decod-
ing. This also sets the transmission rate to 36 scans per second and the polar-
ity to white high.
Non Decoded Output Laser Emulation Transmission
Rate
The Transmission Rate is limited by the terminal’s ability to receive data without
dropping characters.
Default = 36 scans/second.
RS-232 Interface
Non Decoded Output
* 36
100
To Next Page
Loading...
