2 - 16
Wand Emulation Idle
The idle describes the state of the scanner when no data is being transmitted.
When in Wand Emulation mode, you must set the scanner’s idle state to match
the idle state for the device to which the scanner is connected.
Default = Idle
High
.
PDF417 Wand Emulation
Note: The following Wand Emulation functions are for use with the 7837-1200-
9090 interfacescanner only.
Data Block Size
This transmits the PDF417 data in smaller blocks to prevent buffer overflow.
Default = 60.
* Idle High
Idle Low
20
80
40
* 60
To Next Page
Loading...
