EasyManua.ls Logo

NCR Realscan 7837 - Data Editing; Prefix;Suffix Overview; To Add a Prefix or Suffix

NCR Realscan 7837
174 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
iii
Chapter 5 - Data Formatting
Data Format Editor Introduction...........................................5-1
To Add a Data Format ....................................................5-1
Other Programming Selections.......................................5-2
Data Format Editor Commands ......................................5-2
Data Format Editor .........................................................5-4
Data Formatter ................................................................5-5
Alternate Data Formats...................................................5-5
Chapter 6 - Secondary Interface
Secondary Code 39 Wand Emulation ...................................6-1
Secondary RS-232 Connection .............................................6-1
Secondary Non Decoded Output Laser Emulation ...............6-2
Non Decoded Output Laser Emulation Transmission Rate ..6-2
Non Decoded Output Laser Emulation Polarity....................6-3
Non Decoded Laser Emulation Idle......................................6-3
Disabling the Secondary Interface ........................................6-3
Secondary Trigger Mode.......................................................6-4
Chapter 7 - Symbologies
Introduction ...........................................................................7-1
All Symbologies....................................................................7-1
Codabar .................................................................................7-2
Start/Stop Characters......................................................7-2
Check Character..............................................................7-3
Concatenation .................................................................7-4
Message Length..............................................................7-4
Code 39..................................................................................7-6
Start/Stop Characters......................................................7-6
Check Character..............................................................7-7
Message Length..............................................................7-7
Code 39 Append .............................................................7-8
Base 32............................................................................7-8
Full ASCII.......................................................................7-9

Table of Contents

Related product manuals