DS1000 02.10.09 Release Notes
New Features in 02.10.09
6 ā 02.10.09 DS1000 Release Notes
If you press
NUM
to store a new number (automatically in Speed Dial bin 720), you see:
- Enter the trunk number (e.g., 1 for trunk 1), trunk group number (e.g., 90 for group 0), or
ICM
to store Intercom codes +
HOLD
.
- Following Speed Dial programming methods, enter the number you want to store (up to 16
digits long, including
MIC
to store a pause and
FLASH
to store a Flash) +
HOLD
to exit.
- You cannot enter a name using this option.
- If you already have a number stored in bin 20, you see:
- Press
Yes
to enter a new number or
No
to back up to step 4.
OR
If you pressed
VIEW
to view your currently stored number, you see:
- Press
SPK
to exit the
VIEW
mode.
6. You see:
7. Select the Call Forwarding type:
- Dial 2 or press ALL to forward all calls.
- Dial 8 or press TRNK to forward just trunk calls.
8. Once returning to idle, your telephone display will show:
- FWD OFP indicates that Off Premise Call Forwarding is enabled, followed by the number.
- If you selected a Speed Dial bin with a stored name, the name will display instead.
To cancel Call Forwarding Off Premise:
1. Press the ICM key and dial *3.
OR
Press CLEAR + PGM + CFWD. You see:
2. Press NONE.
OR
Dial 0.
OR
Press CLEAR.
3. Off Premise Call Forwarding is cancelled.
To Next Page
Loading...
Need help?
General
