DS1000 02.10.09 Release Notes
New Features in 02.10.09
18 ◆ 02.10.09 DS1000 Release Notes
*. The PIN code is used for both Extension Locking and Walking Class of Service. By default, there
are no PIN codes entered. In addition:
●
An extension user can dial ICM + ##6 to enter or change their PIN number.
●
The operator can dial
ICM + ##3
to erase a co-worker’s PIN number and unlock their extension.
To enter 1807-PIN Code data:
●
When you see PIN CODE?, press HOLD to enter the data entry mode.
●
While in the data entry mode:
- Vol Up scrolls right.
- Vol Down scrolls left.
-
LND backspaces over (erases) the last entered digit.
- CLEAR + HOLD erases the current entry.
- CHECK restores the previous entry.
- HOLD registers the entry and advances to the next prompt.
- CONF exists the program.
Operation
To enable Walking Class of Service at an extension:
When using the procedures that follow to enter a PIN number or extension number:
● CLEAR erases your entire entry.
● LND backspaces over (erases) the last digit entered.
1. Press ICM.
2. Dial ##0.
At a 22- or 34-Button Display Telephone, you see:
At a Super Display Telephone, you see:
If your extension does not have a PIN code already entered, skip to step 4.
3. Enter your own extension number + HOLD.
At a 22- or 34-Button Display Telephone, you see:
To Next Page
Loading...
Need help?
General
