NEC DS1000 Release Notes

DS1000 02.10.09 Release Notes
Enhanced Features in 02.10.09
DS1000 Release Notes 41 ◆ 02.10.09
To enter data:
1. Enter the programming mode.
2. Dial 0202 + HOLD.
3. Press Vol Up until you see: PG RING SRC [NONE].
To see the available entries for this option, press HOLD before going to the next step.
The entries are E (extension), T (trunk), and N (none).
To clear this entry (i.e., reset to NONE), press N or CLEAR.
4. Dial E (3) + Dial the number of the extension that should activate ringing over the External
Page zone + HOLD.
5. Press CONF to exit program 0202.
When entering data, pressing:
● Vol Up advances to next prompt.
● Vol Down backs up to the previous prompt.
● CHECK restores the previous entry.
● HOLD registers the entry and advances to the next prompt.
● CONF exists the program.
Operation
To answer the call that is ringing over the Paging speakers:
1. Lift handset or press SPK.
2. Dial *0.
3. Converse with the caller.
Door Chime Over Page
Door Box chimes can optionally broadcast over External Paging. While Door Box chimes broad-
cast over External Paging, any extension user can dial a code (ICM + *0) to answer the Door Box.
After answering, a keyset user can press a soft key or FLASH to control the Door Box relay. If
Door Box chimes, ringing, and Background Music are all programmed to output over External Pag-
ing, the system uses the following broadcast priority:
● Paging
● Door Box chimes
● Ringing
● Background Music
Programming
0202-Door Chime Over Page
Use this option to enable Door Box chimes over External paging. By default, this option is dis-
abled (N).
To enter data:
1. Enter the programming mode.
2. Dial 0202 + HOLD.
3. Press Vol Up until you see: DOORCHIME OVR PG?.
4. Press Y (9) to enable Door Chimes over External Paging + HOLD.
OR

NEC DS1000 Specifications

General

Brand	NEC
Model	DS1000
Category	Telephone
Language	English