NEC DS1000 Release Notes

DS1000 02.10.09 Release Notes
New Features in 02.10.09
DS1000 Release Notes 11 ◆ 02.10.09
Level 7 prevents long distance calls. These features are no longer available at extension 306.
● The extension 301 user goes to extension 306 and implements Walking Class of Service.
● The extension 301 user can then use 306 to make long distance calls and Page (even though
306 was locked to prevent those features).
Programming
0101-Extension Locking
Enter Y to enable or N to disable Extension Locking. This option is disabled by default.
1801-Exension Class of Service Assignment
Assign Class of Service to extensions.
1801-Access Level
Be sure the operator’s extension has access level 4 or 5. If not, the operator will not be able to erase
a co-worker’s PIN number and unlock their extension. The access code for extension 300 is fixed at
5. Be sure to program this option for the other operators in a multiple-operator setup.
1807-PIN Code
Use this option to assign a PIN code to an extension. PIN codes are 4 digits long, using 0-9, # and
*. The PIN code is used for both Extension Locking and Walking Class of Service. By default, there
are no PIN codes entered. In addition:
●
An extension user can dial ICM + ##6 to enter or change their PIN number.
●
The operator can dial ICM + ##3 to erase a co-worker’s PIN number and unlock their extension.
To enter 1807-PIN Code data:
●
When you see PIN CODE?, press HOLD to enter the data entry mode.
●
While in the data entry mode:
- Vol Up scrolls right.
- Vol Down scrolls left.
-
LND backspaces over (erases) the last entered digit.
- CLEAR + HOLD erases the current entry.
- CHECK restores the previous entry.
- HOLD registers the entry and advances to the next prompt.
- CONF exists the program.
Operation
Locking and Unlocking Your Extension
When using the procedures that follow to enter a PIN number or extension number:
● CLEAR erases your entire entry.
● LND backspaces over (erases) the last digit entered.
To lock your extension:
● Press ICM and dial ##5.
Your DND key winks on while your extension is locked. In addition, you hear pulsating
Intercom dial tone when you press ICM.
To unlock your extension:
1. Press ICM.
You hear pulsating Intercom dial tone.
2. Dial ##5.

NEC DS1000 Specifications

General

Brand	NEC
Model	DS1000
Category	Telephone
Language	English